POROUS TERRACOTTA TREATMENT – 0534

CHARACTERISTICS
This treatment protects porous terracotta from oil, grease, water, etc. It leaves no visible film.

APPLICATION
Do not use at temperatures below 15°C, on hot ground or exposed to the sun. It is applied in 2 or 3 coats on a new or old clean and dry floor, without any trace of other treatment, which would lead to a bad penetration and a bad drying of the product. When the terracotta is moderately porous and the product does not penetrate very well, it can be diluted with the active thinner 0435, which will adjust the viscosity without altering the effectiveness of the treatment 0534.

– On a new floor: after drying, prepare the floor by removing cement efflorescence with our stripper 0820 (see FT). When the floor has been rinsed and is perfectly dry, apply with a brush, roller or sponge the 0534 treatment in abundant and regular cross layers. Make sure that the product is well distributed and that there is no excess. Drying: 4 to 8 hours between each coat.

– On an old floor: it must be free of any previous treatment, use our 0901 heavy duty cleaner (see FT). When the soil is ready and dry, apply treatment 0534 (see ¤ above). Finishing: after drying for 72 hours or more, a finish can be applied that will give a satin appearance, with our palm wax emulsion 0722 or an unbeatable shine with our terracotta patina wax 0007 (see FT).

– Cleaning of brushes: with White Spirit.

– Coverage: 8 to 10 m2 per liter depending on the porosity of the support.

PRECAUTIONS FOR USE
Read the safety label carefully – Work in a well-ventilated area – Do not swallow – Keep out of reach of children. Information given in good faith, but we are not responsible for it.

see data sheet

See data sheet